The Fixed Rack Mount gives you a stable, set-and-forget mounting point for VOLTRA I on a rack upright. Once it’s installed, you’ve got a fixed station you can rely on every session.
Note: The Fixed Rack Mount is sold as a pair, so you’ll receive two mounts when you buy it.
Best for
-
Home gyms and facilities that want a permanent station
-
Coaches and clinicians who want repeatable positioning
-
Anyone who prefers maximum stability over quick height changes
Before you start
-
Make sure you’ve got the correct bolt type for your rack hole size (the kit supports common rack standards).
-
Clear a safety zone before installing and training:
-
At least 83 in (2.1 m) clear on both sides of the mount
-
In front: VOLTRA I cable length + your movement space + 20 in (0.5 m) buffer
-
Setup
-
Assemble the mount
Use the included screwdriver to attach the Mount Base to the Fixed Mount Platform using the bolts. -
Choose your mounting height
Pick the rack holes that match the anchor height you want most often. If you’re installing both mounts as a pair, choose a matching height on both sides.
-
Bolt the mount to the rack
-
Hold the mount flush against the rack upright and line up the rack installation holes.
-
Insert all bolts with the relevant washers in the correct order and position, before fully tightening any single bolt.
-
Tighten the bolts using the included wrench until the mount is fully secure and doesn’t rock.
-
Mount VOLTRA I and do a quick test pull
-
Attach VOLTRA I to the mount and make sure it’s properly locked before pulling.
-
Start light and do a smooth test pull. If anything shifts, stop and re-tighten before you go heavier.
Removing the mount
-
Unload first. Bring resistance down and return the cable to the start.
-
Unload and remove VOLTRA I first.
-
Use the wrench to remove the bolts, then take the mount off the rack.
Safety checks
Before you go heavy:
-
Bolts are fully tightened and the mount doesn’t rock.
-
The mount is sitting flush on the upright (no angle or gap).
-
Your rack upright is solid and won’t shift under load.
-
No one and nothing is inside the safety zone.
-
Do a light test pull first.
-
Keep your line of pull clear and the cable path clean.
Safety notes
-
Indoor use only. Don’t leave the mount outdoors or expose it to rain, sun, water jets, or high humidity.
-
Keep children away from VOLTRA I and the mount.
-
Maintain control of the handle or accessory. Sudden release can cause snap-back. Return the cable to the start position before letting go.
-
Don’t adjust VOLTRA I during a rep. Return the cable to the start position before making any changes.
-
Don’t train under the influence of alcohol, drugs, medication, or sedatives.
Maintenance
-
Wipe down with a damp cloth and mild detergent.
-
Check bolts and hardware periodically. If anything loosens, stop and re-tighten before training.